The use of Bricks or Pavers to develop a walkway or patio matches a home in a way that is unrivaled. In addition, installing a Brick or Paver pathway does not always require a pro.
The secret to installing a Brick or Paver Walkway is to first correctly prepare the location where the bricks/pavers are to be installed. The location ought to be dug out a minimum of a foot down, getting rid of all topsoil and clay soil. In addition, string lines ought to be strung on each side of the walkway. The string lines indicate the completed height of the sidewalk.
As soon as the location has been dug down, 3/4" gravel stone need to be laid in and tamped down securely. The height between the tamped down sand and the stringline should equate to the thickness of the brick or paver.
Now that you have a steady base, put a 1" pipeline or ledger board the length of the sidewalk on either side of the walkway. Using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will produce a level surface location to lay the bricks/pavers.
Now place on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the prepared location. These strips will act as your sidewalk border and assistance to preserve the stability and shape of the sidewalk.
You can then begin to lay the bricks/pavers when this is done. There are numerous patterns you can lay. I especially like the Herring Bone pattern. The secret to laying the bricks/pavers is to make sure that they interlock with each other. Always stagger adjacent rows of bricks by 1/2 of a brick to get more info interlock them. This will again assist preserve the stability of the pathway.
When developing the pathway, inevitably bricks/pavers will need to be cut or divided. Unless you wish to purchase or lease a costly wetsaw, I would suggest acquiring an easy brick/paver splitter. It is essentially a sculpt with a wide end that is the width of the bricks/pavers. To really cut/split the brick/paver, lay it in a bed of sand and location the sculpt at a 75 degree angle over the area where you wish to break the brick. Using a hammer strike the butt end of the sculpt firmly. You might need to do this a couple of times. You might also desire to flip the brick/paver over and strike the opposite of the brick using the hammer and chisle. Within one or two strikes the brick/paver ought to break cleanly. If your walkway has curves you will require to buy/rent a wetsaw. get more info
After setting up the bricks, develop up the outdoors edges with extra sand, and after that shovel in the topsoil and load down securely.
Spread stone dust over the new pathway and sweep into the fractures. This will finish the interlocking of the bricks and help to get rid of any weed development.
In addition, setting up a Brick or Paver walkway does not always need a pro. The key to setting up a Brick or Paver Walkway is to very first appropriately prepare the area where the bricks/pavers are to be installed. Now that you have a steady base, place a 1" pipe or journal board the length of the walkway on either side of the walkway. These strips will act as your sidewalk border and aid to keep the integrity and shape of the sidewalk. Inevitably bricks/pavers will require to be cut or divided when developing the pathway.